Sliding MagMover 24" PRO

Why Sliding MagMover posts?

Posts can be moved to match the distance between attachment points of the item to be hung (less than 24”/61cm).

• This allows the retrieval of two Round ClikMagnets or Mini ClikMagnets from two FlatHats.

The Sliding Dual MagMover 24” PRO has the standard Acme thread for attachment to the MagPole or most other threaded poles for installation/retrieval at great heights and on lower ceilings...while standing on the floor.

Product Description:

• Has two moveable MagMover ‘posts’; each with a corkscrew
• Made of sturdy aluminium
• Threaded handle fits most Acme threaded poles
• Light weight
• Patented
• Re-usable - over and over again
• Installation of ClikMagnets (+ display item) to any position in a 360 degree radius (metal being present)
• Has the additional benefit of also functioning as the Dual MagMover 6” and the Dual MagMover 24”

How to Use the Sliding Dual MagMover 24” PRO for Install into Suspended FlatHats:

1. Thread the Sliding Dual MagMover 24” PRO onto the end of a MagPole or an extension pole.
2. Slide the Sliding MagMover 24” PRO’s posts to the same distance apart as the distance between the attachment points on the display.
3. Connect the display (with LoopLine™ – or with FlushMount Clips at each attachment point), to the two Round ClikMagnet’s centre rings.
4. Place each Round ClikMagnet’s centre ring (+ display) onto the orange side of the posts of the Sliding MagMover 24” PRO - as shown.
5. Lift the assembly to the metal inside the first FlatHat. Allow the first Round ClikMagnet to “clik” to the metal. Walk to the next FlatHat, lift the assembly to allow the second Round ClikMagnet to “jump” to the metal. Your display is hung!

How to Use the Sliding Dual MagMover 24” PRO to Safely Retrieve both ClikMagnets (+ display) from Suspended FlatHats.

1. The two corkscrews on the Sliding Dual MagMover 24” PRO are used to retrieve two ClikMagnets (+ display).
2. Thread the Sliding Dual MagMover 24” PRO onto the end of a MagPole or an extension pole.
3. Slide the Sliding MagMover 24” PRO’s posts to the same distance apart as the distance between the attachment points on the display.
4. Turn each corkscrew outward. Fully insert one corkscrew through the centre ring of the first ClikMagnet - as shown. Pull downward. Fully insert the next corkscrew through the centre ring of the second ClikMagnet. Pull downward. The coils of the corkscrews will hold the ClikMagnets (+ display) from falling.

Note: For easy take down stand close to the underside of the display.

Note: Remove from the display, the LoopLine or the FlushMount Clips with their ClikMagnets. They are ready to be re-used for the installation of the next display.