1-866-298-9684 Questions? Call Us
How to Install FlatHats from Ceiling Beams: See Clik-Clik Banana Kit
How to Use the Sliding Dual MagMover 24” PRO to Install a Display from Suspended FlatHats.
How to Use a Sliding dual MagMover 24” PRO to Safely Retrieve a Display from Suspended FlatHats.
Note: For easy take down stand close to the underside of the display.
Note: Remove from the display, the connecting LoopLine™ or FlushMount Clips with their ClikMagnets. These are ready for the installation of the next display.
NOTE: MAGMOVER WIDTH MUST MATCH THE DISTANCE BETWEEN SIGN GROMMETS FOR EASY TAKE-DOWN – 24″ OR CUSTOM-WIDTH MAGMOVER RECOMMENDED.
To be able to hang/remove signage in areas where the ceiling height is greater than the reach of the MagPole…. while standing on the floor.
Yes. However, the FlatHat is small and if signage is not required at the location, it will not be visually distracting. It will be ready when signage is required.
The lower end of the cable should be the higher than the expected top position of the sign. If the sign sizes are varied, the cable could be shorter and the length difference filled with LoopLine™. An advantage of the FlatHat is that a shorter extension pole can be used because the reach needs to be to the FlatHat and not to a tall ceiling…. while standing on the floor.
The thicker the aircraft cable (3/32 in/2.54mm or greater), the less stretch in the cable. If there is stretch in the cable, the pull to remove the Round ClikMagnet from the FlatHat causes the cable to stretch, and the release of the Round ClikMagnet will cause the thin aircraft cable to quickly retract and “boing” around ceiling rafters etc.
It would be impossible to remove the sign if the distance is not exact. It is impossible because as one Round ClikMagnet is captured, the movement of the MagMover to the second Round ClikMagnet causes the sign to push the aircraft cable ahead of the sign. The install and removal of the Round ClikMagnets becomes very easy and quick to do when the width of the MagMover is the same as the distance between the grommets.
Select your region below to get started.